ACS Floor Pro Self Levelling Compound is a cementitious
self-levelling compound with outstanding flow, workability and
bonding properties. ACS Floor Pro Self Levelling Compound
is suitable where a thickness of between 3mm and 50mm is
required and can be used over new or existing interior floors
that have been properly prepared and primed with CCS Super
Polymer.
Preparation
Concrete floors must be structurally sound, clean and dry.
Surface must be free from all contaminants such as dust, dirt,
wax, grease, asphalt, latex and gypsum compounds, adhesives,
paint, curing and sealing compounds all of which may act as a
bond breaker. Concrete must be free from laitance, efflorescence
and not be subject to hydrostatic pressure. Mechanically prepare
the floor using recommended preparation methods such as shot
blasting, scarifying, diamond grinding, or other suitable methods
to provide a roughened, clean, sound, solid and open porous
surface. Acid etching is not a suitable method of preparing the
subfloor. Remove all dust and debris from the floor by vacuuming
the surface with a suitable H Class industrial cleaner which must
be equipped with a Hepa filter.
All concrete sub floors must be fully cured and dry in accordance
with AS 1884 (Less than 75% relative humidity when measured
in accordance with ASTM F2170). Ambient temperature,
surfaces and materials should be maintained at temperatures
higher than 10°C and below 35°C. For floors with a high humidity
content or subject to rising damp, apply a suitable moisture
barrier compound. Refer to ACS Technical Bulletin on Concrete
Subfloor Preparation for detailed information on preparation of
the subfloor.
Application
Pour the mixed ACS Floor Pro Self Levelling Compound onto the
prepared substrate and spread into place using a long handled gauged
spreader. ACS Floor Pro Self Levelling Compound seeks its own level
during the first 10 – 15 minutes after pouring. Subsequent applications
of leveller should be made whilst the material on the floor is still fluid and
has a wet edge, to allow for easy blending. ACS Floor Pro Self Levelling
Compound can be applied from 3mm to 50mm thick in one application.
Thicker applications may require a longer cure. It is recommended
that spiked shoes be worn, to minimise any indentations in the product
whilst still fluid.
Setting Time
Allow a cure time of 12 hours at 23°C for foot traffic. Allow ACS Floor
Pro Self Levelling Compound to cure 24 hours at 23°C before applying
carpet, carpet tile or ceramic tile floor coverings. Allow ACS Floor Pro
Self Levelling Compound to cure 72 hours at 23°C before applying
impervious floor coverings, such as timber or vinyl. These times can
be impacted by air temperature, substrate temperature and relative
humidity. Thicker layers will extend drying times.
Clean Up
Wash all tools in water immediately after use.
Downloads
Features and Benefits
- May be applied to a thickness of 3mm to 50mm in a
single application - Tear and rain resistant recyclable PE bags which
prevent loss from broken bags - Accurate and reliable bag weights
- Excellent bonding properties
- Outstanding flow and workability
- Trafficable at 12 hours
- May accept some floor coverings within 24 hours
– refer to Temperature Factors
Packaging
ACS Floor Pro Self Levelling Compound comes in a 20kg bag.
For further information consult the Safety Data Sheet (SDS) and read the Technical Data Sheet (TDS) carefully before use. SDS and TDS documents are available in the Resources section of this website and by contacting ACS Customer Service support line on 1800 077 744.
