ACS Enviro Epoxy HB-100 is a new generation self-priming, waterborne coating technology developed with the well-being of the applicator and environment in mind.
It is a robust yet flexible coating that exhibits high moisture, chemical and oil resistance with the ability to build virtually any thickness. It will provide a durable, hard-wearing coating for heavy traffic environments.
ACS Enviro Epoxy HB-100 is a tow pack, 100% solids, water-based, low odour, low VOC epoxy coating system for internal concrete flooring. It can be tinted with ACS compatible tints.
Preparation
Ensure the floor to be coated is free of all efflorescence, laitance, dirt, grease, oil, paint, curing agents, dust, wax and all other contaminants. If the floor is smooth or if curing agents have been applied, mechanical grinding or abrasive blast cleaning is recommended to ensure proper adhesion. Conduct a water test before applying ACS Enviro Epoxy HB-100 by sprinkling water drops on various parts of the floor and observe how quickly they absorb into the surface.
Application
Apply ACS Enviro Epoxy HB-100 with a lambswool applicator or mohair roller. If required use a spiked roller to remove any air bubbles.
- First Coat
Apply ACS Enviro Epoxy HB-100 at a rate of 4-6m2 per litre. If a textured or anti-slip surface is required, apply at 5m2 per litre and then broadcast an appropriate anti-slip medium such as CCS Slip Reduction Granules. Allow 8 hours drying then remove any unbonded excess anti-slip with broom or vacuum. Ensure that all dust and any other contamination is removed thoroughly before applying the next coat to prevent fish-eyeing.
- Second Coat
Apply second coat inside recoat window (8-24hours). After 24 hours the floor may no longer accept a second coat without the possibility of fish-eyeing and subsequent delamination. If applying a second coat outside the recommended recoat window time, sanding of the surface will be required to ensure proper inter-coat adhesion.
Pot Life
The pot life is the time taken for the mixed Part A and B to start gelling in the mix bucket/vessel.
The pot life for the 10 litre kit is 35-45minutes.
Clean Up
Wash all equipment in CCS Solvent immediately following application and mixing.
Curing Time
Allow the surface to cure for at least 6 hours for touch dry. Allow 18 hours before subjecting it to pedestrian traffic, and 7 days before subjecting it to chemicals or severe abrasion.
Downloads
Features and Benefits
- Easy to use 3:1 mix ratio
- Applicator and environment friendly
- Safe waterborne technology
- Low odour and low VOC
- Self-levelling and high build
- High gloss and clarity
- Durable and suitable for high traffic
- Chemical, stain and wear resistant
- No fish-eyeing or delamination with proper application
- Can be tinted to a solid colour
Packaging
ACS Enviro Epoxy HB-100 is a two-part system, including 7.5L Part A and 2.5L Part B
For further information consult the Safety Data Sheet (SDS) and read the Technical Data Sheet (TDS) carefully before use. SDS and TDS documents are available in the Resources section of this website and by contacting ACS Customer Service support line on 07 3412 8111 or 1800 077 744.